High Performance Miniature Coax Products

SSI Product Line

 

coax 0,1" (2,54mm) Pitch Socket interconnects
coax BNC Interconnects
coax PCB Connectors
coax SMA / SMB / SMC Type Interconnects
coax Single Signal Carrier Systems
coax Specification
coax Electrical Test Data
coax Ordering information

 

 

 

Meritec Single Signal Interconnect (SSITM) Assemblies accurrately control analog and digital signals for applications with 3ns to sub ns edge rates. The assemblies are engineered to match requirements for controlled impedance, high speed and low crosstalk.

Meritec's SSI Assemblies are .100" pitch centerline .025" square socket, high performance, cost effective terminations. The socket contacts are resistance welded to the conductors for ultimate electrical continuity.

Square socket terminations may be housed individually or consolidated into multi-position carrier systems for grouped interfacing with single, dual or triple row headers. Side and end stackable carriers, latch and eject keyed carriers and 96 position triple row DIN compatible carriers are available. Keying and polarization plugs are optional.

SSI Assemblies are also available using BNC, SMA, SMB, or SMC connectors. Virtually any combination of connectors may be used on opposite ends to meet specific application requirements.

Meritec cables are designed for single or differential mode transmission lines and are available with impedance from 50 to 100 ohms. Among the cable options are twisted pair, coax, twinax and shielded twisted pair. Each cable is designed to maximize performance.

 

 

 

  • Built for reliability in applications where performance is critical
  • Engineered to match application requirements for controlled impedance, highspeed and low crosstalk
  • Overmolded to provide reliable strain relief

  • Square socket terminations offer:
    - Resistance welded socket contacts/conductors for ultimate electrical continuity
    - Mating with .025" square or round pins
    - Side and end stackability on .100" grid
    - Choice of pinout configurations
    - Axial or right angle cable exits

  • 100% electrically tested. Products must pass all standard checks for continuity, open and shorts and HiPot. See Electrical Test Data for typical performance

  • UL/CSA recognized

 


HOME | ABOUT | PRODUCTS | SOLUTIONS | CONTACT

If you experience any problems please contact webmaster @ ap-products.de

Copyright 2005 by A P Products GmbH - all rights reserved

Last update August 02, 2005